D-Link DES-1210-52/ME - Power Saving Commands; Config Power_Saving Mode; Config Power_Saving

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
137
19 1
POWER SAVING COMMANDS
The Power Saving commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
config power_saving
mode
[hibernation | led | length_detection | port] [enable | disable]
config power_saving
[hibernation | led [all | <portlist>] | port [all | <portlist>]] [add | delete] time_range1
<range_name 20> time_range2 <range_name 20> {clear_time_range}
show power_saving
{hibernation | led | length_detection | port}
Each command is listed in detail, as follows:
config power_saving mode
Purpose
To configure the power saving mode on the switch.
Syntax
config power_saving mode [hibernation | led | length_detection
| port] [enable | disable]
Description
The config power_saving mode command is used to configure the
power saving mode on the switch.
Parameters
hibernation – Configure the hibernation state to enable or disable.
The default value is disabled.
led – Configure the led state to enable or disable. The default value
is disabled.
length_detection – Configure the length detection state to enable or
disable. The default value is disabled.
port – Configure ports state to be enabled or disabled.
[enable | disable] – Enable or disable the power saving feature.
Restrictions
Only Administrator or operator–level users can issue this command.
Example usage:
To configure the power saving mode on the switch:
DES-1210-52/ME:5# config power_saving mode port hibernation enable
Command: config power_saving mode port hibernation enable
Success!
DES-1210-52/ME:5#
config power_saving
Purpose
To configure the power saving on the switch.
Syntax
config power_saving [hibernation | led [all | <portlist>] | port [all