D-Link DES-1210-52/ME - Config Multicast Filter; Show Multicast Filter Port_Mode

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
172
DES-1210-52/ME:5# show fdb aging_time
Command: show fdb aging_time
Unicast MAC Address Aging Time = 300 (seconds)
DES-1210-52/ME:5#
config multicast filter
Purpose
To configure multicast filtering.
Syntax
config multicast filter <portlist> [forward | filter]
Description
The config multicast filtering_mode command enables filtering of
multicast addresses.
Parameters
<portlist> - A port or range of ports to be configured.
forward - Forwards unregistered multicast packets.
filter - Filter unregistered multicast packets.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure multicast filtering
DES-1210-52/ME:5# config multicast filter 3-5 forward
Command: config multicast filter 3-5 forward
Success.
DES-1210-52/ME:5#
show multicast filter port_mode
Purpose
To display multicast filtering settings on the Switch.
Syntax
show multicast filter port_mode
Description
The show multicast filter port_mode command displays the
multicast filtering settings.
Parameters
None.
Restrictions
None.
Example usage:
To show multicast filtering settings:
DES-1210-52/ME:5# show multicast filter port_mode
Command: show multicast filter port_mode
Port Multicast Filtering Mode
------ --------------------------------------------
1 Forward Unregistered Groups
2 Forward Unregistered Groups
3 Forward Unregistered Groups
4 Forward Unregistered Groups