D-Link DES-1210-52/ME User Manual

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
99
characters can be used.
Parameters
<string 128> − A maximum of 128 characters is allowed. A NULL
string is accepted if there is no location desired.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure the Switch location to “HQ”:
DES-1210-52/ME:5# config snmp system_location HQ
Command: config snmp system_location HQ
Success.
DES-1210-52/ME:5#
config snmp system_name
Purpose
To configure the name of the location of the Switch.
Syntax
config snmp system_name <string 128>
Description
The config snmp system_ name command configures the name of
the Switch.
Parameters
<string 128> − A maximum of 128 characters is allowed. A NULL
string is accepted if there is no location desired.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure the Switch name for “DES-1210:
DES-1210-52/ME:5# config snmp system_name DES-1210
Command: config snmp system_name DES-1210
Success.
DES-1210-52/ME:5#
config snmp warmstart_traps
Purpose
To enable or disable the warm start traps of SNMPon the Switch.
Syntax
config snmp warmstart_traps [enable | disable]
Description
The config snmp warmstart_traps command enable or disable the
warm start traps of the Switch.
Parameters
[enable | disable] – Enable or disable the warm start traps of the
Switch.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To enable SNMP warm start traps for the Switch:
DES-1210-52/ME:5# config snmp warmstart_traps enable
Command: config snmp warmstart_traps enable

D-Link DES-1210-52/ME Specifications

General

Brand	D-Link
Model	DES-1210-52/ME
Category	Network Router
Language	English