D-Link DES-1210-52/ME - Show Link_Aggregation

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
236
Parameters
[enable | disable] – Enables or disables the link aggregation state.
Restrictions
Only administrator or operator-level users can issue this command.
Example usage:
To enable the link aggregation feature:
DES-1210-52/ME:5# config link_aggregation state enable
Command: config link_aggregation state enable
LA Module has been enable
DES-1210-52/ME:5#
show link_aggregation
Purpose
To display the current link aggregation configuration on the Switch.
Syntax
show link_aggregation {group_id <value 1-8> | algorithm}
Description
The show link_aggregation command displays the current link
aggregation configuration of the Switch.
Parameters
group_id <value 1-8> − Specifies the group ID. The Switch allows up
to 8 link aggregation groups to be configured. The group number
identifies each of the groups.
algorithm – shows which hash Algorithm is used for link aggregation
distribution.
Restrictions
None.
Example usage:
To display Link Aggregation configuration:
DES-1210-52/ME:5# show link_aggregation
Command: show link_aggregation
LA State : Enable
Link Aggregation Algorithm = MAC_source
DES-1210-52/ME:5#
v