D-Link DES-1210-52/ME - Show Utilization

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
141
Port Number : 1
RX Frames TX Frames
------------------ -------------------
CRC Error 0 Excessive Deferral 0
Undersize 0 CRC Error 0
Oversize 0 Late Collision 0
Fragment 8 Excessive Collision 0
Jabber 0 Single Collision 0
Drop Pkts 0 Collision 0
DES-1210-52/ME:5#
show utilization
Purpose
To display real-time port utilization statistics.
Syntax
show utilization [ports {<portlist>} | cpu | mem]
Description
The show utilization command displays the real-time utilization
statistics for ports in bits per second (bps) for the Switch, and for the
CPU in percentage.
Parameters
ports – Entering this parameter will display the current port utilization
of the Switch.
<portlist> – Specifies a range of ports to be displayed.
cpu – Entering this parameter will display the current CPU utilization
of the Switch.
mem – Entering this parameter will display the current memory
utilization of the Switch.
Restrictions
None.
To display the port 2 utilization statistics:
DES-1210-52/ME:5# show utilization ports 2
Command: show utilization ports 2
Port TX/sec RX/sec Util
------ -------- ---------- ----
2 0 0 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
To display the cpu utilization statistics:
DES-1210-52/ME:5# show utilization cpu
Command: show utilization cpu
CPU Utilization :
-------------------------------------------------------------------------------
Five Seconds - 1 % One Minute - 1 % Five Minutes - 1 %