D-Link DES-1210-52/ME - Config Flood_Fdb; Show Flood_Fdb; Clear Flood_Fdb

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
169
DES-1210-52/ME:5#
config flood_fdb
Purpose
To configure the Switch’s forwarding database on the Switch.
Syntax
config flood_fdb [log | trap] [enable | disable]
Description
The config flood_fdb command configures dynamically learned
entries from the Switch’s forwarding database.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure FDB dynamic entries:
DES-1210-52/ME:5# config flood_fdb trap disable log enable
Command: config flood_fdb trap disable log enable
Success.
DES-1210-52/ME:5#
show flood_fdb
Purpose
To display the Switch’s forwarding database on the Switch.
Syntax
show flood_fdb
Description
The show flood_fdb command displays dynamically learned entries
from the Switch’s forwarding database.
Parameters
None.
Restrictions
None.
Example usage:
To display FDB dynamic entries:
DES-1210-52/ME:5# show flood_fdb
Command: show flood_fdb
Flooding FDB State : Enabled
Log State : Disabled
Trap State : Disabled
Value VLAN ID MAC Address Time stamp
--------- ------------ ------------------- ------------------
DES-1210-52/ME:5#
clear flood_fdb
Purpose
To clear the Switch’s forwarding database of all dynamically learned
MAC addresses.