D-Link DES-1210-52/ME - Show Igmp_Snooping Group; Show Igmp_Snooping Forwarding

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
270
Version : 2
Data Driven Learning Aged Out : Disable
Data Driven Learning State : Disable
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a ALL
show igmp_snooping group
Purpose
To display the current IGMP snooping group configuration on the
Switch.
Syntax
show igmp_snooping group [vlan <vlan_name 32> | vlanid
<vidlist> | ports <portlist>] <ipaddr> {data_driven}
Description
The show igmp_snooping group command displays the current
IGMP snooping group configuration on the Switch.
Parameters
vlan <vlan_name 32> − The name of the VLAN for which IGMP
snooping group configuration information is to be displayed. Up to
20 characters can be used.
vlanid <vidlist> − The ID of the VLAN for which IGMP snooping
group configuration infor mation is to be displayed.
ports <portlist> − The ports of the VLAN for which IGMP snooping
group configuration infor mation is to be displayed.
<ipaddr> − Specifies to display the IP address of IGMP snooping
group.
{data_driven} − Specifies to display the data driven of IGMP
snooping group.
Restrictions
None.
Example usage:
To show igmp snooping group:
DES-1210-52/ME:5# show igmp_snooping group vlan default
Command: show igmp_snooping group vlan default
Total Entries : 0
DES-1210-52/ME:5#
Reports : 1
Port Member : 3,4
Total Entries : 1
DES-1210-52/ME:5#
show igmp_snooping forwarding
Purpose
To display the IGMP snooping forwarding table entries on the
Switch.
Syntax
show igmp_snooping forwarding {vlan <vlan_name 32> | vlanid
<vidlist>}
Description
The show igmp_snooping forwarding command displays the