DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
4
Figure 2–2 The ? Command
When entering a command without its required parameters, the CLI displays the prompt: command:
config account message and the options listed below.
Figure 2–3 Example Command Parameter Help
In this case, the command config account was entered with the parameter <username>. The CLI will then
prompt to enter the <username> with the message, command: config account. Every command in the
CLI has this feature, and complex commands have several layers of parameter prompting.
In addition, after typing any given command plus one space, users can see all of the next possible sub-
commands, in sequential order, by pressing the ? key.
To re-enter the previous command at the command prompt, press the up arrow cursor key. The previous
command appears at the command prompt.
Figure 2–4 Using the Up Arrow to Re-enter a Command
In the above example, the command config account was entered without the required parameter
<username>, the CLI returned the command: config account prompt. The up arrow cursor control key
To Next Page
Loading...
