D-Link DES-1210-52/ME - Page 406

DES-1210-52/ME L2 Metro Ethernet Switch CLI Reference Guide
388
Parameters
[<portlist> | all] – Specify a port or ports to be configured.
Admin status – Defines admin status of ports on the switch.
Tx- Tx only
Rx – Rx only
Both – Tx and RX
Disable – admin status disabled.
Restrictions
None.
Example usage:
To configure LLDP admin status
DES-1210-52/ME:5# config lldp ports 2 admin_status disable
Command: config lldp ports 2 admin_status disable
Success.
DES-1210-52/ME:5#
config lldp ports
Purpose
To define LLDP management address advertisement on a port or
ports.
Syntax
config lldp ports [<portlist>|all] mgt_addr [ipv4 <ipaddr>| ipv6
<ipv6addr>] [enable | disable]
Description
The config lldp ports mgt_addr command defines if lldp will
advertise the switch’s IP address the command is per port on the
switch.
Parameters
[<portlist> | all] – Specify a port or ports to be configured.
mgt_addr [ipv4 <ipaddr> | ipv6 <ipv6addr>] – defines wether the
management address (IPv4 or IPv6 address) advertisement will be
enabled or disabled
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To configure LLDP management address advertisement:
DES-1210-52/ME:5# config lldp ports 1 mgt_addr ipv4 100.1.1.2 enabled
Command: config lldp ports 1 mgt_addr ipv4 100.1.1.2 enabled
Success.
DES-1210-52/ME:5#
config lldp ports
Purpose
To define LLDP management basic TLVs advertisement on a port or
ports.
Syntax
config lldp ports [<portlist>|all] basic_tlvs [all |
{port_description | system_name | system_description |
system_capabilities}] [enable | disable]
Description
The config lldp ports basic TLVs command defines if lldp will