A
BOUT
T
HIS
G
UIDE
– 8 –
◆ Updated syntax for the command "delete" on page 723.
◆ Updated range for the command "exec-timeout" on page 730.
◆ Added the command "terminal" on page 737.
◆ Updated parameter options for the command "snmp-server
enable traps" on page 778.
◆ Added the command "snmp-server enable port-traps mac-notification"
on page 781 and "show snmp-server enable port-traps" on page 782,
◆ In Chapter "Flow Sampling Commands" on page 803 - removed and
replaced previous commands with descriptions of a new command set.
◆ Added the command "accounting commands" on page 830.
◆ Added description of new command "mac-learning" on page 874.
◆ Updated the description of command usage under "port security" on
page 875.
◆ Added description of new command "port security mac-address-as-
permanent" on page 877.
◆ Added description of new command "ip dhcp snooping limit rate" on
page 904.
◆ Added description of new command "ipv6 dhcp snooping option
remote-id" on page 913.
◆ Added description of new command "ipv6 dhcp snooping option
remote-id policy" on page 914.
◆ Updated parameters for the commands "ip source-guard binding" on
page 920 and "ip source-guard max-binding" on page 923.
◆ Added description of new command "ip source-guard mode" on
page 924.
◆ Added the new command "clear ip source-guard binding blocked" on
page 924
◆ Updated syntax of command "show ip source-guard binding" on
page 925.
◆ Added new section describing commands for "IPv6 Source Guard" on
page 926.
◆ Added option to allow zeros for command "ip arp inspection validate"
on page 935.
◆ Added new parameters for IPv4 and IPv6 filters to the command
"permit, deny (MAC ACL)" on page 965.
To Next Page
Loading...
