A
BOUT
T
HIS
G
UIDE
– 9 –
◆ Added the command "clear access-list hardware counters" on
page 973.
◆ Updated description of parameters for the command "capabilities" on
page 977.
◆ Added the command "discard" on page 979.
◆ Added description of seven new DDM commands beginning
with"transceiver-threshold-auto" on page 989 and ending with
"transceiver-threshold voltage" on page 995.
◆ Added the command "port channel load-balance" on page 1004.
◆ Added the command "lacp timeout" on page 1011.
◆ Added the command "storm-sample-type" on page 1029.
◆ Updated descriptions of commands "auto-traffic-control alarm-clear-
threshold" on page 1037 and "auto-traffic-control alarm-fire-threshold"
on page 1038 now able to be set using packet rate (packets per
second).
◆ Added description of new command "loopback-detection action" on
page 1048 and removed the command loopback-detection mode.
◆ Updated information in Command Usage section for the command
"show mac-address-table" on page 1061.
◆ Added description of new command "spanning-tree tc-prop-stop" on
page 1088.
◆ Updated parameters for "protocol-vlan protocol-group (Configuring
Interfaces)" on page 1155.
◆ Added address mask parameter to the command "mac-vlan" on
page 1160.
◆ Updated parameters for the command "match" on page 1186.
◆ Updated range for the command "ip igmp snooping priority" on
page 1206.
◆ Added the commands "clear ip igmp snooping groups dynamic" on
page 1220 and "clear ip igmp snooping statistics" on page 1221.
◆ Added description of new commands"ip igmp authentication" on
page 1230 and "show ip igmp authentication" on page 1235.
◆ Updated range for the command "ip igmp max-groups" on page 1233.
◆ Added the commands "ip multicast-data-drop" on page 1234 and
"show ip multicast-data-drop" on page 1238.
To Next Page
Loading...
