GE CARESCAPE - Selecting the hemodynamic waveform sweep speed; Selecting the invasive pressure noise reduction filter; Selecting the displayed invasive pressure format; Selecting invasive pressure as the primary heart rate source

Invasivepressures
1.Selecttheinvasivepressureparameterwindow.
2.SelecttheSetuptab.
3.SelectOptimizeScale.
TheScaleselectionwillnowshowtheautomaticlimitrange.
NOTE
TheOptimizeScaleselectionwillnotautomaticallychange
tomatchthewaveform,youwillalwayshavetoselectit
manuallyeverytime.
Selectingthehemodynamicwaveformsweepspeed
NOTE
Thissettingadjuststhewaveformspeedforallofthe
hemodynamicparameters.
1.Selecttheinvasivepressureparameterwindow.
2.SelecttheSetuptab.
3.SelectanumericvaluefromtheHemodynamicSweepSpeedlist.
Thesmallerthevalue,theslowerthesweepspeed.
Selectingtheinvasivepressurenoisereductionlter
NOTE
Ifarterialpressureisusedtotriggertheintra-aorticballoon
pump,usethe40Hzpressurelter.
1.Selecttheinvasivepressureparameterwindow.
2.SelecttheSetuptab.
3.SelectanumericvaluefromtheFilterHzlist.
Thesmallertheltervalue,thegreaterthedegreeoflteringthatoccurs.
Selectingthedisplayedinvasivepressureformat
Youcanchoosetodisplaysystolic,diastolicormeanpressurevaluesindifferent
formats.
1.Selecttheinvasivepressureparameterwindow.
2.SelecttheSetuptab.
3.SelecttheformatfromtheParameterFormatlist:
●Meanonly:Onlythemeanvalueisshown.
●Sys/Dia(Mean):Allvaluesareshown,butthesys/diavaluesareshownina
biggerfont.
●(Mean)Sys/Dia:Allvaluesareshown,butthemeanvalueisshowninabigger
font.
●Sys/Dia/Mean:Allvaluesareshowninanequallybigfont.
Selectinginvasivepressureastheprimaryheartratesource
TheprimaryheartratecanbecalculatedfromtheECGleads,SpO
2
measurement,
orinvasivepressurewaveform.
2062971-001CARESCAPEModularMonitors241