GE CARESCAPE - Messages related to gas exchange measurement

Messages
Message
Location
ExplanationWhattodo
●Vent:Extnot
supported
●al.areaInterfaceddeviceisnot
supported.
●SeetheUnityNetwork
InterfaceDevice(ID)
Operator'sManualfor
supporteddevices.
●Iftheproblempersists,
contactauthorizedservice
personnel.
●Vent:InAlarm●al.areaInterfaceddeviceneedstobe
checked.
●Checkthepatientstatus.
●Checktheventilatortubing
andpatientconnection.
●Checktheinterfaceddevice.
●Vent:Lowbattery●al.areaInterfaceddeviceneedstobe
checked.
●Checktheinterfaceddevice.
●Iftheproblempersists,
contactauthorizedservice
personnel.
●Vent:Noextdevice●al.areaInterfaceddeviceisnotdetected
byUnityNetworkInterface
Device(ID).
●Checktheinterfaceddevice.
●Iftheproblempersists,
contactauthorizedservice
personnel.
●Ventilatorinterface
removed
al.areaThecablebetweentheUnity
NetworkInterfaceDevice(ID)
andtheinterfaceddevicehas
beenremoved.
●Reconnectthecableifyou
wanttorestarttheinterface.
●Zeroingerror
●param.
Zeroinghasfailed.●Repeatthezeroing.
●Zeroing
●param.
Zeroingisinprogress.
●Waituntilthezeroingis
completed.
Messagesrelatedtogasexchangemeasurement
Forinformationregardingalarmprioritiesandescalationtimes,seetheCARESCAPEModular
MonitorsSupplementalInformationManual.
Makesureyouarefamiliarwiththegenericlayoutofthescreen.Thiswillhelpyouidentify
whereonscreenthefollowingmessagesappear.Themessagelocationisindicatedwiththe
followingabbreviations:
●al.area=alarmarea
●param.=parameterwindow
●report=reportview
●wavef.=waveformarea
2062971-001CARESCAPEModularMonitors495