GE CARESCAPE - Changing the Patient Spirometry loop type; Saving Patient Spirometry reference loops; Selecting a Patient Spirometry reference loop; Erasing a Patient Spirometry reference loop

PatientSpirometry
NOTE
InORandPACUsoftwarepackages,thissettingalsoaffects
theSpiro1splitscreenaccordingly.
1.SelectthePatientSpirometryparameterwindow.
2.SelectSetup.
3.SelectanoptionfromtheShowVolumelist.
ChangingthePatientSpirometrylooptype
TochangethedisplayedloopfromaPaw-VollooptoaFlow-Vollooporviceversa,
presstheChangeLoopmodulekey,or:
1.SelectthePatientSpirometryparameterwindow.
2.SelectLoops.
3.SelectPaw-VolLooporFlow-VolLoop.
NOTE
InORandPACUsoftwarepackages,theloopviewshows
Ppeak,Pplat,PmeanandPEEPtotnumbers.Inothersoftware
packages,theloopviewshowsPpeak,Pplat,Pmean,PEEPe
andPEEPinumbers.
SavingPatientSpirometryreferenceloops
Savealoopforreferenceofthecurrentlungmechanics,andwhenevermajorchanges
inthepatient'sstatusoccur.PresstheSaveLoopmodulekey,or:
1.SelectthePatientSpirometryparameterwindow.
2.SelectLoops>SaveLoop.
Themonitorautomaticallydisplaystherstsavedloopasareferenceloop.Youcan
saveuptosixpairsofloops.Ifyousaveanotherpairofloopsafterthesixthone,the
secondoldestreferenceloopisautomaticallyerased.
SelectingaPatientSpirometryreferenceloop
Youcanselectasavedlooptothescreenforreference.
1.SelectthePatientSpirometryparameterwindow.
2.SelectLoops.
3.SelectaloopfromtheReferenceLooplist.
ErasingaPatientSpirometryreferenceloop
Youcaneraseunnecessaryreferenceloops.
1.SelectthePatientSpirometryparameterwindow.
2.SelectLoops.
3.ErasetheloopbyselectingEraseSelected.
PrintingaPatientSpirometryloop
Youcanprintthecurrentlydisplayedloop.
1.SelectthePatientSpirometryparameterwindow.
2062971-001CARESCAPEModularMonitors327