IDEC SmartAXIS Touch FT1A Series User Manual

1 Touch
29-20 SmartAXIS Touch User's Manual
● Installation
• Make a panel cut-out on the panel with the dimensions shown below.
• The Touch has the mounting clip positions not only on the top and bottom side (0.3 to 0.35 N•m).
CAUTION
• Do not tighten excessively, otherwise the Touch may warp and cause wrinkle on the display, or
impair the waterproof characteristics.
• If the mounting clips are tightened obliquely to the panel, the Touch may fall off the panel.
• When installing the Touch into a panel cut-out, make sure that the gasket is not twisted. Especially
when re-installing, take special care because any twists in the gasket will impair the waterproof
characteristics.
• Even in the panel thickness range, there is a risk that the waterproof characteristics cannot be
maintained due to the panel materials and size.
Unit: mm
A B Panel Cut-out
66.0
+1.0
0
105.0
+1.0
0
1.0 to 5.0
B
A
TOP
BOTTOM
Mounting Clip Position
Mounting Clip
Panel

IDEC SmartAXIS Touch FT1A Series Specifications

General

Brand	IDEC
Model	SmartAXIS Touch FT1A Series
Category	Controller
Language	English