JRC JUE-501 - Page 185

6. Web Menu System
6-79
Chapter6 Web Menu System
3)
Input PIN
To change PIN Mode, PIN input is required.
4)
Change Status
Changes PIN Mode
Change PIN
Contents
5)
Input Old PIN
(Input SIM PUK)
Input 4-digits old PIN
(Input PUK when the PIN was locked.)
6)
Input New PIN
Input new PIN. The new PIN must be 4-digits number.
7)
Retype New PIN
Retype new PIN for confirmation. Do not use copy and paste.
8)
Change PIN
Register new PIN.
If the value of old PIN (or the PUK) was wrong, the SIM page is
reloaded with “PIN (or PUK) Remaining” subtracted.
Facility Lock
Change Status
Contents
9)
Network
Enable locks MCC (Mobile Country Code) and MNC (Mobile
Network Code).
10)
Network Subset
Enable locks Network Subset Code.
11)
Service Provider
Enable locks Service Provider Code.
12)
Corporate
Enable locks Corporate Code.
13)
SIM/USIM
Enable locks particular one SIM/USIM Card.
14)
PIN Code input box
There are no initial PIN Codes.
The number (from 8 to 16 digits) which is input for the first time shall
be applied as the facility PIN Code. If forgot the facility PIN Code,
changing the status and changing the PIN Code
will be disabled.
Please do not forget the facility PIN Codes.
15)
Change Status
Changes status.
To change status, password is required. Input the password to the 13)
text box located on the left side of “Change Status” button.
Change PIN
Contents
16)
Select Type
Target to change PIN
Network/Network Subset/Service Provider/Corporate
17)
Input Old PIN
Input from 8 to 16 digits old PIN
18)
Input New PIN
Input new PIN. The new PIN must be from 8 to 16 digits number.
19)
Retype New PIN
Retype new PIN for confirmation. Do not use copy and paste.
20)
Change PIN
Register new Facility PIN.
Secondary SIM
Contents
21)
Secondary SIM
Use or non-use of Secondary SIM
System reboot is required to apply this setting.
22)
Set
Registers the setting.
NOTE
• Communications on FBB system might be disabled by changing SIM Configurations.
• We strongly recommend you to change PIN codes for the security reason.