Appendix M TCP Accelerator Installation Procedure
M-4
5. If you want the program files to be installed in the default directory, click on Next. To select a
different directory, click on Change…, and select the required directory, then click on Next. The
“Preparing to Install” screen is displayed, as shown below, and TCP Accelerator performs
pre-installation checks:
If the program detects that your computer is not fully optimized for TCP Accelerator, the following
screen is displayed: If you see this screen, click on OK when prompted to reboot your computer. This is
a one time optimization, and is not repeated for subsequent TCP Accelerator releases. After rebooting
your computer, do from step 1 again.
To Next Page
Loading...
