EXi: AL-1 Analog Synthesizer
160
For a list of AMS sources, see “Alternate Modulation Source
(AMS) List” on page 901.
Intensity [–99…+99]
This controls the depth and direction of the AMS
modulation.
Filter B
The EG parameters for Filter B are the same as those for
“Filter A,” above.
When Link is On, or when the Filter Routing is set to Single
or 24dB (4-Pole), all of these parameters are grayed out.
5–3c: Filter Modulation
Filter A Frequency
AMS 1 [List of AMS Sources]
This selects the first modulation source to control Filter A’s
Frequency. For a list of AMS sources, see “Alternate
Modulation Source (AMS) List” on page 901.
Intensity [–99…+99]
This controls the depth and direction of the Frequency
modulation.
Intensity Mod AMS [List of AMS Sources]
This selects an AMS source to modulate the intensity of
AMS 1.
Intensity [–99…+99]
This controls the depth and direction of the Intensity Mod
AMS.
AMS 2 [List of AMS Sources]
This selects a second modulation source to control Filter A’s
Frequency. For a list of AMS sources, see “Alternate
Modulation Source (AMS) List” on page 901.
Intensity [–99…+99]
This controls the depth and direction of AMS 2.
Filter B Frequency
The settings for Filter B are the same as those for “Filter A
Frequency,” above.
When Link is On, or when the Filter Routing is set to Single
or 24dB (4-Pole), all of these parameters are grayed out.
v
5–3: Page Menu Commands
• Compare →p.112
• Write Program →p.112
• Exclusive Solo →p.113
•PAGE →p.126
•MODE →p.126
To Next Page
Loading...
Need help?
General
