Korg NAUTILUS Series

PROGRAM > MOD-7: Patch Panel 4–1: Patch Panel
315
(Connection) [Jack name]
This read-only parameter shows the jack to which the
selected jack is connected, including the normalled
connection. If nothing is connected to the jack, the bottom
line reads “(No Connection).”
If the selected jack is an output connected to multiple inputs,
only the first connection is shown, followed by an ellipse.
If the default connection from Algorithm is active, it is
shown in parentheses.
Input or Output Level [0…100]
This sets the input or output volume level of the jack. It
duplicates the similarly-named parameter on the block’s
page.
Jump
Press the Jump button to go directly to the page of the
selected jack’s block. For instance, if you’ve selected one of
the inputs or outputs of VPM Oscillator 2, pressing Jump
will take you to the VPM Osc 2 page.
Disconnect button
Pressing the Disconnect button clears all cables connected
to the jack.
v 4–1: Page Menu Commands
• Compare →p.112
• Write Program →p.112
• Exclusive Solo →p.113
• Delete All Connections →p.282
• Copy VPM Oscillator →p.347
• Swap VPM Oscillators →p.347
• PAGE →p.126
• MODE →p.126