Korg NAUTILUS Series

SEQUENCER mode
508
Off: The track will not be output from the L/R bus, IFX1–12
buses, or Individual 1–4 buses. Choose the Off setting if you
want the program oscillator output of the track to be
connected in series to a master effect. Use Send1 (to MFX1)
and Send2 (to MFX2) to specify the send levels.
Tip: You can create a wide variety of routings by using each
track’s Bus Select and the Chain to and Chain settings (8–
5a) that follow the insert effect.
Send1 (MFX1) [000…127]
Send2 (MFX2) [000…127]
For each track, these parameters set the send level to master
effects 1 and 2. These settings are valid when Bus Select is
set to L/R or Off. When IFX 1–12 are selected, the send
levels to master effects 1 and 2 are set by the Send1 and
Send2 parameters of the Insert FX page, after the sound has
passed through IFX1–12.
If Bus Select is set to 1…4 or 1/2…3/4, these settings are
ignored.
The Send 1 and 2 setting you specify here are used when
playing-back or recording from the beginning of the song. If
you modify these settings during recording, your changes
will be recorded as performance data; the send amounts will
change accordingly during playback. You can also modify
these settings during playback. However if Send 1 and 2 data
has been recorded, the settings will change according to the
recorded data.
If Status (2–1a) is either INT or Both, CC#93 and #91
can be received to control send 1 and 2 respectively and
change their settings. When you switch songs or return to
the beginning of a song, tracks whose Status is EXT,
EX2 or Both will transmit these settings via MIDI. This
data will be transmitted on the MIDI channel of each
track as set by MIDI Channel (2–1a). The actual send
level is determined by multiplying the value of these
parameters with the send level settings of the oscillator(s)
of the program used by the track (Send1 and “Send2,”
Program 8–1d).
Track 02…16 (Track Number)
These settings specify the program oscillator output bus and
master effect send levels for MIDI tracks 2 through 16. They
are the same as for track 1. See “Track 01”:.
v 8–1: Page Menu Commands
• Compare →p.112
• Memory Status →p.521
• Exclusive Solo →p.113
• Copy Insert Effect →p.122
• Swap Insert Effect →p.122
• Drum Kit IFX Patch →p.437
• Put Effect Setting to Track →p.554
• FF/REW Speed →p.523
• Set Location (for Locate Key) →p.523
•PAGE →p.126
•MODE →p.126