SAMPLING: Page Menu Commands Truncate (for Sample Edit)
613
Auto Sampling Setup: Automatically-set parameters and their values
–: Not set automatically
[ ]: Set automatically according to the parameter settings in
the dialog box
*1 Edit SAMPLING mode parameters
*2 Uses the input source specified as Source Audio.
*3: If IFX is Off this will be L/R. If IFX1…12 is selected
this will be IFX1…12.
*4 L-Mono if the Source Audio is Mono-L, R-Mono if it is
Mono-R, and Stereo if it is Stereo
*5 When Save to=RAM
*6 Specify the BUS Select of that IFX1…12. If effects are
chained, specify the last IFX in the chain.
Truncate (for Sample Edit)
This command deletes unwanted data that lies outside the
Start and End points. Use this command when you wish to
delete silence at the beginning or end of the sample.
Note: If you wish to delete unneeded (unplayed) sample data
after setting the Start, Loop Start, and End (2–1d), use the
“Truncate (for Loop Edit)” page menu command found in
Loop Edit.
1. Use Sample Select (1–1b) to select the sample that you
wish to edit, and use Start and End to specify the
editing range.
You can press the Play button to hear the portion that will
be left by the Truncate command.
2. Select Truncate to open the dialog box.
[Initialize] [REC Audio Input]
[Auto Resampling through
IFX]
Input (Input Source)
*1
Input 1& 2, USB 1& 2 [Source Audio]
*2
Input 1& 2, USB 1& 2
Input1, USB 1
Bus Select Off [IFX]
*3
Off
FX Ctrl Bus Off Off Off
REC Bus Off Off Off
Send1/2 000 000 000
Pan L000 L000 L000
Level 127 127 127
Input2, USB 2
Bus Select Off [IFX]
*3
Off
FX Ctrl Bus Off Off Off
REC Bus Off Off Off
Send1/2 000 000 000
Pan R127 R127 R127
Level 127 127 127
Sampling Setup
(Name)
Source Bus L/R L/R L/R
Source Direct Solo (N/A) (N/A) (N/A)
Trigger Sampling START button Sampling START button Sampling START button
Metronome Precount (N/A) (N/A) (N/A)
Pre Trigger REC – – –
Resample Manual Manual Auto
REC Sample Setup
Save to RAM [Save to] RAM
Mode Stereo [Source Audio]
*4
Stereo
Rec Level +0.0 +0.0 +0.0
Auto +12dB On On On
*5
On
Auto Loop On On – –
Select Directly – – – –
Routing
Bus Select (All OSCs to) L/R – [IFX]
FX Crtl Bus Off – Off
REC Bus Off – Off
Send1/2 127 – 000
Insert FX Bus Select (Post IFX) – L/R
*6
L/R
*6
To Next Page
Loading...
Need help?
General
