Korg NAUTILUS Series

MEDIA mode
706
Load a single Drum Kit
The selected drum kit will be loaded into the drum kit
number you specify.
1. If you wish to load a drum kit other than the one
already selected, use “Drum Kit” (upper line) to select
the drum kit you wish to load.
Note: Whenever you’ve selected an individual Program,
Combination, Drum Kit, or Wave Sequence from within a
PCG file, you can play it from the keyboard
immediately–no need to load it into memory! For more
information, see “Auditioning sounds from disk” on
page 695.
2. In “To Drum Kit” (lower line), select the loading
destination drum kit.
3. To load the data, press the OK button. To cancel
without loading, press the Cancel button.
Note: If “Multiple Select” (0–1a) is checked and you’ve
selected more than one bank, the data will be loaded starting
with the drum kit you specified in the “To” field.
Load Arpeggio Patterns
This loads all arpeggio pattern data in the .PCG file.
1. Press the OK button if you want to load, or press the
Cancel button if you decide not to load.
Load Arpeggio Pattern Bank
Loads all arpeggio pattern data in the selected bank into the
bank specified for the load destination.
1. Use “To” to select where to load the data.
2. Press the OK button if you want to load, or press the
Cancel button if you decide not to load.
Load an Arpeggio Pattern
Loads the selected single arpeggio pattern data into the
arpeggio pattern number selected as the load destination.
1. For the “Arp Pattern” (upper row), when loading an
arpeggio pattern other than the one selected, reselect
the arpeggio pattern to load.
Note: The selected arpeggio pattern will sound when you
play the keyboard, even if it hasn't been loaded yet. This is
useful when you want to check the arpeggio patterns before
loading them. For more information, see “PCG Preview” on
page 696.
2. For the other “Arp Pattern” (lower row), select where
you want to load the arpeggio pattern.
3. Press the OK button if you want to load, or press the
Cancel button if you decide not to load.
Note: If “Multiple Select”(0–1a) is selected and you’ve
selected more than one wave sequence, the data will be
loaded starting with the wave sequence you specified in the
"To” field.
Load Wave Sequences
All wave sequence data of the .PCG file will be loaded.
1. To load the data, press the OK button. To cancel
without loading, press the Cancel button.
Load Wave Sequence Bank
[INT, USER–A…G and AA…GG]
All wave sequence data of the selected bank will be loaded
into the bank you select as the load-destination.
1. Use the “To” field to select the load-destination bank.
2. To load the data, press the OK button. To cancel
without loading, press the Cancel button.
Note: If “Multiple Select” (0–1a) is checked and you’ve
selected more than one bank, the data will be loaded starting
with the bank you specified in the “To” field.
The A bank can hold 150 Wave Sequences, while each
G–T bank can hold only 32. If you load from a stored
INT bank into one of the USER banks, only the first 32
Wave Sequences will be loaded (INT–000 …031).
Conversely, if you load from a stored USER bank into the