MEDIA mode
708
Load a single Song
Data for the selected song will be loaded into the song
number you specified as the load destination.
1. If you wish to load a song other than the selected song,
use Song (upper line) to re-select the song to be
loaded.
2. In “To Song” (lower line), select the loading
destination song.
3. If you’ve enabled the “with Region Data” check-box,
the Song’s region data will be loaded following the last
region number existing in internal memory, with data
packed into each consecutive location (Append load).
At this time, the region numbers of the song will be
reassigned so that they correspond correctly to the region
data.
4. To load the data, press the OK button. To cancel
without loading, press the Cancel button.
Load Tracks
The event data of all tracks in the selected song will be
loaded into the song you specify as the loading destination.
However, it is not possible to specify an uncreated song as
the loading destination.
1. In Song, specify the loading destination song.
2. If you’ve enabled the “with Region Data” check-box,
the region data used by the song tracks being loaded
will also be loaded following the last region number
existing in internal memory, with data packed into
each consecutive location (Append load).
At this time, the region numbers of the tracks in the song
will be reassigned so that they correspond correctly to the
region data.
3. To load the data, press the OK button. To cancel
without loading, press the Cancel button.
Load Pattern Data
The selected user pattern will be loaded into a user pattern of
the selected loading destination song.
1. If you wish to load a user pattern other than the one
already selected, use Pattern (upper line) to re-select
the user pattern that you wish to load.
2. In “To Song” and Pattern (lower line), select the
loading destination song and user pattern.
3. To load the data, press the OK button. To cancel
without loading, press the Cancel button.
Load Regions
All region data will be loaded from the .SNG file.
1. Use “Select Regions Allocation” to specify how the
song data in the .SNG file will be loaded.
Append: The data will be packed into each consecutive
location following the last region number existing in
internal memory. Choose this method when you want to
load additional region data from the drive without erasing
the region data already in internal memory.
Clear: All region data in internal memory will be erased,
and the region data will be loaded in the configuration
that existed when it was saved. Choose this method when
you want to replicate the configuration that you saved,
such as immediately after turning the power on.
If you load using Append, the region numbers used by the
song may no longer correspond correctly. If so, you will
need to re-select the region numbers used by the song.
When loading song data, you will normally use Load
.SNG or Load a Song and check the “with Region Data”
setting. Even if you load using Append, the region
numbers of the song will automatically be re-specified so
that the song will correspond to the correct region data.
2. To load the data, press the OK button. To cancel
without loading, press the Cancel button.
To Next Page
Loading...
Need help?
General
