Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 205
Methods that involve remote servers are timed out if the remote servers are offline. In this case the next method is
tried. Each method is tried from left to right and continues until a method either approves or rejects a user. If a
remote server is used for primary authentication it is recommended to configure secondary authentication as
'local'. This will enable the management client to login via the local user database if none of the configured
authentication servers are alive.
Service Port: The network port number this client bound to provide service.
Command Authorization Method : This section allows you to limit the CLI commands available to a user.
Client: The management client for which the configuration below applies.
Method: Method can be set to one of the following values:
no: Command authorization is disabled. User is granted access to CLI commands according to his
privilege level.
tacacs: Use remote TACACS+ server(s) for command authorization. If all remote servers are offline, the
user is granted access to CLI commands according to his privilege level.
Cmd Lvl: Authorize all commands with a privilege level higher than or equal to this level. Valid values are 0-15.
Cfg Cmd: Also authorize configuration commands.
Accounting Method : This section allows you to configure command and exec (login) accounting.
Client: The management client for which the configuration below applies.
Method: Method can be set to one of the following values:
no: Accounting is disabled.
tacacs: Use remote TACACS+ server(s) for accounting.
Cmd Lvl: Enable accounting of all commands with a privilege level higher than or equal to this level. Valid values
are in the range 0 to 15. Leave the field empty to disable command accounting.
Exec: Enable exec (login) accounting.
Buttons
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
To Next Page
Loading...
Need help?
General
