EasyManuals Logo

Lantronix SISPM1040 L3 Series User Manual

Lantronix SISPM1040 L3 Series
502 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 20
System > IP Address > Advanced Settings
This page lets you set more advanced IP settings, IP interfaces and IP routes. The maximum number of
interfaces supported is 128 and the maximum number of routes is 128.
Basic Settings
Mode: Configure whether the IP stack should act as a Host or a Router. In Host mode, IP traffic between
interfaces will not be routed. In Router mode traffic is routed between all interfaces. Router mode is required for
Router configuration.
DNS Server: This setting controls the DNS name resolution done by the switch. There are four servers available
for configuration, and the index of the server presents the preference (less index has higher priority) in doing DNS
name resolution. These modes are supported:
No DNS server: No DNS server will be used.
Configured IPv4: Explicitly provide the valid IPv4 unicast address of the DNS Server in dotted decimal
notation. Make sure the configured DNS server is reachable (e.g., via PING) for activating DNS service.
Configured IPv6: Explicitly provide the valid IPv6 unicast (except linklocal) address of the DNS Server.
Make sure the configured DNS server could be reachable (e.g., via PING6) for activating DNS service.
From any DHCPv4 interfaces: The first DNS server offered from a DHCPv4 lease to a DHCPv4-enabled
interface will be used.
From this DHCPv4 interface: Specify from which DHCPv4-enabled interface a provided DNS server
should be preferred.
From any DHCPv6 interfaces: The first DNS server offered from a DHCPv6 lease to a DHCPv6-enabled
interface will be used.
From this DHCPv6 interface: Specify from which DHCPv6-enabled interface a provided DNS server
should be preferred.

Table of Contents

Other manuals for Lantronix SISPM1040 L3 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lantronix SISPM1040 L3 Series and is the answer not in the manual?

Lantronix SISPM1040 L3 Series Specifications

General IconGeneral
BrandLantronix
ModelSISPM1040 L3 Series
CategorySwitch
LanguageEnglish

Related product manuals