Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 445
Maintenance > Factory Defaults
You can reset the configuration of the switch on this page. The IP setup can be retained. The new configuration is
available immediately, which means that no restart is necessary.
Check or uncheck the Keep IP setup checkbox.
At the āAre you sure you want to reset the configuration to Factory Defaults?ā prompt click Yes or No.
Yes: Click to reset the configuration to Factory Defaults.
No: Click to return to the System > System Information page without resetting the configuration.
Note: Restoring factory default can also be performed by making a physical loopback between port 1 and port 2
within the first minute from switch reboot. In the first minute after boot, 'loopback' packets will be transmitted at
port 1. If a 'loopback' packet is received at port 2 the switch will do a restore to default.
To Next Page
Loading...
