Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 13
Web User Interface
Initial Configuration
This chapter describes how to configure and manage the switch using the web user interface. With this facility,
you can easily configure and monitor, via any switch port, all switch functions, including port activity, Spanning
tree, port aggregation status, multicast traffic, VLAN and priority status, etc.
Switch default values are listed below:
IP Address 192.168.1.77
Subnet Mask 255.255.255.0
Default Gateway 192.168.1.254
Username admin
Password admin
After the initial switch configuration, you can browse it. For instance, type http://192.168.1.77 in the address row in
a browser to display the Login screen which prompts for the username and password in order to login.
The default username is admin and password is admin. For first time use, enter the default username and
password, and then click the Login button. The login process is complete. The Login menu requires you to enter
the complete username and password; the switch will not provide a shortcut to username / password
automatically. This seems inconvenient but is safer.
The switch allows two or more users with administrator rights to manage this switch. The last administrator setting
will provide the configuration used by the switch.
When you log in to the switch Web UI, you can use either IPv4 or IPv6. The switch has the DHCP function
disabled by default, so if you do not have DHCP server to provide IP addresses to the switch, you must use the
switch default IP address of 192.168.1.77.
To optimize the display effect, we recommend you use Microsoft IE 6.0 / above, Netscape V7.1 / above, or Firefox
V1.00 / above and use 1024x768 resolution. The switch supports neutral web browser interface.
The SISPM1040-3xxx-L3 has the DHCP server function disabled by default; if you do not have a DHCP server
providing IP addresses to the switch, the switch defaults to IP address 192.168.1.77.
To Next Page
Loading...
Need help?
General
