Lantronix SISPM1040 L3 Series User Manual

Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 358
OSPF > Configuration > Area Authentication
This page lets you set OSPF area authentication parameters. It is used to apply the authentication to all the
interfaces belong to the OSPF area. No entry exists initially.
Delete: Check to delete the entry. It will be deleted during the next save.
Area ID: The OSPF area ID.
Auth. Type: The authentication type on an area is applied to all the interfaces belong to that area.
The authentication type on an IP interface or a virtual link overrides the authentication type on an area and is
useful if different interfaces in the same area use different authentication types.
Specify the authentication type to be used:
Simple Password: Simple password authentication (default).
Message Digest: MD5 digest authentication.
Buttons
Add New Entry: Click to add new entry.
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
Messages:
The new entry {0.0.0.0} is duplicated.
Example:

Lantronix SISPM1040 L3 Series Specifications

General

Brand	Lantronix
Model	SISPM1040 L3 Series
Category	Switch
Language	English