EasyManuals Logo

Lantronix SISPM1040 L3 Series User Manual

Lantronix SISPM1040 L3 Series
502 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #297 background imageLoading...
Page #297 background image
Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 297
APS
The APS module implements the protocol and linear protection switching mechanisms for point-to-point VLAN-
based ETH SNC (Subnetwork Connections) in Ethernet transport networks. The APS (Automatic Protection
Switching) protocol is used to ensure that switching is done bidirectionally in the two ends of a protection group,
as defined in ITU-T G.8031.
This Recommendation specifies linear 1+1 protection switching architecture and linear 1:1 protection switching
architecture. The linear 1+1 protection switching architecture operates with either unidirectional or bidirectional
switching. The linear 1:1 protection switching architecture operates with bidirectional switching.
APS Configuration
This page lets you create and configure an APS Instance. From the default page, click the button to display
the APS Configuration table.
↓ ↓ ↓ ↓
Configuration Data
APS #: The ID of the APS (1-32). You can create 1-32 APS instances. Click on the link to get to the APS instance
page, where you can reset counters and issue commands.
Port: The Port this flow is attached to.
SF Trigger: Selects whether Signal Fail (SF) comes from the link state of a given Port, or from a Down-MEP.

Table of Contents

Other manuals for Lantronix SISPM1040 L3 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lantronix SISPM1040 L3 Series and is the answer not in the manual?

Lantronix SISPM1040 L3 Series Specifications

General IconGeneral
BrandLantronix
ModelSISPM1040 L3 Series
CategorySwitch
LanguageEnglish

Related product manuals