EasyManuals Logo

Lantronix SISPM1040 L3 Series User Manual

Lantronix SISPM1040 L3 Series
502 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #475 background imageLoading...
Page #475 background image
Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 475
DHCP Per Port Mode Configuration
The DHCP Per Port function lets you assign an IP address based on the switch port the device is connected to.
This will speed up installation of IP cameras, as the cameras can be configured after they are on the network.
The DHCP Per Port assignment lets you know which IP was assigned to which camera.
Note: to prevent IP conflict, each switch can be allocated a different IP range.
To configure DHCP Per Port via the Web UI, navigate to the Configuration > System > IP menu path.
Parameter descriptions: The DHCP Per Port parameters and buttons are described below.
DHCP Per Port Mode: at the dropdown select Enable or Disable the DHCP Per Port function globally. The default is
Disabled.
IP: enter the IPv4 IP address range to be used when the DHCP Per Port function is enabled (e.g., 192.168.10.20 -
192.168.10.37). The DHCP Per Port IP range must be within the interface subnet. Note that DHCP Per Port with IPv6 is not
supported at this time. The DHCP Per Port IP range must equal the switch port number excluding uplink ports (e.g., 16).

Table of Contents

Other manuals for Lantronix SISPM1040 L3 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lantronix SISPM1040 L3 Series and is the answer not in the manual?

Lantronix SISPM1040 L3 Series Specifications

General IconGeneral
BrandLantronix
ModelSISPM1040 L3 Series
CategorySwitch
LanguageEnglish

Related product manuals