EasyManuals Logo

Lantronix SISPM1040 L3 Series User Manual

Lantronix SISPM1040 L3 Series
502 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #424 background imageLoading...
Page #424 background image
Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 424
Diagnostics
This section provides a set of system diagnostic test provided for troubleshooting purposes.
Diagnostics > ICMP Ping (IPv4)
This page lets you issue ICMP (IPv4) PING packets to troubleshoot IP connectivity issues.
Hostname or IP Address: The address of the destination host, either as a symbolic hostname or an IP Address.
Payload Size: Sets the size of the ICMP data payload in bytes (excluding the size of Ethernet, IP and ICMP
headers). The default value is 56 bytes. The valid range is 2-1452 bytes.
Payload Data Pattern: Sets the pattern used in the ICMP data payload. The default value is 0. The valid range is
0-255.
Packet Count: sets the number of PING requests sent. The default value is 5 packets. The valid range is 1-60
packets.
TTL Value: Sets the Time-To-Live /TTL) field value in the IPv4 header. The default value is 64 seconds. The valid
range is 1-255 seconds.
VID for Source Interface: This field can be used to force the test to use a specific local VLAN interface as the
source interface. Leave this field empty for automatic selection based on routing configuration. Note: You may
only specify either the VID or the IP Address for the source interface.
Source Port Number: This field can be used to force the test to use a specific local interface with the specified
port number as the source interface. The specified port must be configured with a suitable IP address. Leave this
field empty for automatic selection based on routing configuration. Note: You may only specify either the Source
Port Number or the IP Address for the source interface.
Address for Source Interface: This field can be used to force the test to use a specific local interface with the
specified IP address as the source interface. The specified IP address must be configured on a local interface.
Leave this field empty for automatic selection based on routing configuration. Note: You may only specify either
the VID or the IP Address for the source interface.

Table of Contents

Other manuals for Lantronix SISPM1040 L3 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lantronix SISPM1040 L3 Series and is the answer not in the manual?

Lantronix SISPM1040 L3 Series Specifications

General IconGeneral
BrandLantronix
ModelSISPM1040 L3 Series
CategorySwitch
LanguageEnglish

Related product manuals