Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 203
Security > Management > Privilege Levels
This page lets you view and set privilege levels on a per group basis.
Group Name: The name identifying the privilege group. In most cases, a privilege level group consists of a single
module (e.g., LACP, RSTP, or QoS), but a few of them contains more than one. The following description defines
these privilege level groups in detail:
System: Contact, Name, Location, Timezone, Daylight Saving Time, Log.
Security: Authentication, System Access Management, Port (contains Dot1x port, MAC based and the
MAC Address Limit), ACL, HTTPS, SSH, ARP Inspection, and IP source guard.
IP: Everything except 'ping'.
Port: Everything except 'Cable Diagnostics'.
Diagnostics: 'ping' and 'Cable Diagnostics'.
Maintenance: CLI- System Reboot, System Restore Default, System Password, Configuration Save,
Configuration Load and Firmware Load. Web- Users, Privilege Levels and everything in Maintenance.
Debug: Only present in CLI.
Privilege Levels: The Privilege Levels can be configured between 0 to 15 (where 0 is the lowest level and 15 is
the highest level) Every group has an authorization Privilege level for the following sub groups: read-only, read-
write. User Privilege should be same or greater than the authorization Privilege level to have access to that
function.
Buttons
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.