Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 230
Security > ARP Inspection > Dynamic Table
Entries in the Dynamic ARP Inspection Table are shown on this page. The Dynamic ARP Inspection Table
contains up to 256 entries, and is sorted first by port, then by VLAN ID, then by MAC address, and then by IP
address. All dynamic entries are learning from DHCP Snooping.
Each page shows up to 99 entries from the Dynamic ARP Inspection table, default being 20, selected through the
"entries per page" input field. When first visited, the web page will show the first 20 entries from the beginning of
the Dynamic ARP Inspection Table.
The "Start from” port address, "VLAN", "MAC address" and "IP address" input fields let you select the starting
point in the Dynamic ARP Inspection Table.
Port: Switch Port Number for which the entries are displayed.
VLAN ID: VLAN-ID in which the ARP traffic is permitted.
MAC Address: User MAC address of the entry.
IP Address: User IP address of the entry.
Translate to static: Select the checkbox to translate the entry to static entry.
Buttons
Auto-refresh: Check this box to refresh the page automatically every 3 seconds.
Refresh: Refreshes the displayed table starting from the input fields.
First Page: Updates the table starting from the first entry in the Dynamic ARP Inspection Table.
Next Page: Updates the table, starting with the entry after the last entry currently displayed.
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
To Next Page
Loading...
Need help?
General
