Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 340
Event Notification > Log > Syslog
Configure System Log settings on this page.
Server Mode: Indicates the server mode operation. When the mode operation is enabled, the syslog message
will send out to syslog server. The syslog protocol is based on UDP communication and received on UDP port
514 and the syslog server will not send acknowledgments back sender since UDP is a connectionless protocol
and it does not provide acknowledgments. The syslog packet will always be sent out even if the syslog server
does not exist. Possible modes are:
on: Enable syslog server mode operation.
off: Disable syslog server mode operation (default).
Server Address: Indicates the IPv4/IPv6 host address of syslog server. If the switch uses the DNS feature, it can
also be a domain name.
Server Port: Indicates the service port of syslog server.
Buttons
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
To Next Page
Loading...
Need help?
General
