Lantronix SISPM1040 L3 Series User Manual

Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 355
OSPF > Configuration > Network Area
This page lets you set OSPF area parameters. It is used to specify the OSPF enabled interface(s). When OSPF is
enabled on the specific interface(s), the router can provide the network information to the other OSPF routers via
those interfaces.
Delete: Check to delete the entry. It will be deleted during the next save.
Network Address: IPv4 network address.
Mask Length: IPv4 network mask length.
Area ID: The OSPF area ID.
Buttons
Add New Entry: Click to add new entry.
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
Messages: The entry {Network Address:0.0.0.0, Mask Length:24} address range overlaps with {Network
Address:0.0.0.0, Mask Length:24}.
Example:

Lantronix SISPM1040 L3 Series Specifications

General

Brand	Lantronix
Model	SISPM1040 L3 Series
Category	Switch
Language	English