Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 241
Security > RADIUS > Status
This page provides an overview of the status of the RADIUS servers configured on the RADIUS Server
Configuration page.
# : The RADIUS server number. Click to navigate to detailed statistics for this server (see below).
IP Address: The IP address of this server.
Authentication Port: UDP port number for authentication.
Authentication Status: The current status of the server. This field takes one of the following values:
Disabled: The server is disabled.
Not Ready: The server is enabled, but IP communication is not yet up and running.
Ready: The server is enabled, IP communication is up and running, and the RADIUS module is ready to
accept access attempts.
Dead (X seconds left): Access attempts were made to this server, but it did not reply within the
configured timeout. The server has temporarily been disabled but will get re-enabled when the dead-time
expires. The number of seconds left before this occurs is displayed in parentheses. This state is only
reachable when more than one server is enabled.
Accounting Port: UDP port number for accounting.
Accounting Status: The current status of the server. This field takes one of the following values:
Disabled: The server is disabled.
Not Ready: The server is enabled, but IP communication is not yet up and running.
Ready: The server is enabled, IP communication is up and running, and the RADIUS module is ready to
accept access attempts.
Dead (X seconds left): Access attempts were made to this server, but it did not reply within the
configured timeout. The server has temporarily been disabled but will get re-enabled when the dead-time
expires. The number of seconds left before this occurs is displayed in parentheses. This state is only
reachable when more than one server is enabled.
Buttons
Auto-refresh: Check this box to refresh the page automatically every 3 seconds.
Refresh: Click to refresh the page immediately.
To Next Page
Loading...
Need help?
General
