Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 240
NAS-IPv6-Address (Attribute 95): The IPv6 address to be used as attribute 95 in RADIUS Access-Request
packets. If this field is left blank, the IP address of the outgoing interface is used.
NAS-Identifier (Attribute 32): The identifier - up to 253 characters long - to be used as attribute 32 in RADIUS
Access-Request packets. If this field is left blank, the NAS-Identifier is not included in the packet.
Server Configuration: The table has one row for each RADIUS server and several columns:
Delete: To delete a RADIUS server entry, check this box. The entry will be deleted during the next Save.
Hostname: The IPv4/IPv6 address or hostname of the RADIUS server.
Auth Port: The UDP port to use on the RADIUS server for authentication. Set to 0 to disable authentication.
The officially assigned port number for RADIUS Accounting is 1812. Note: by default, many access servers use
port 1645 for authentication requests.
Acct Port: The UDP port to use on the RADIUS server for accounting. Set to 0 to disable accounting.
The officially assigned port number for RADIUS Accounting is 1813. Note: by default, many access servers use
port 1646 for accounting requests.
Timeout: This optional setting overrides the global timeout value. Leaving it blank will use the global timeout
value.
Retransmit: This optional setting overrides the global retransmit value. Leaving it blank will use the global
retransmit value.
Key: You can change the setting which overrides the global key. Leaving it blank won't change the current key.
Buttons
Add New Server: Click to add a new RADIUS server. An empty row is added to the table, and the RADIUS
server can be configured as needed. Up to 5 servers are supported.
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
Messages:
Authentication Error Invalid secret key configuration parameter
To Next Page
Loading...
