Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 55
Port Management > Link Aggregation > Static Configuration
This page lets you configure Aggregation hash mode and the aggregation group. Aggregation involves using
multiple ports in parallel to increase link speed beyond the limits of a port and to increase redundancy for higher
availability. (Also Port Aggregation, Link Aggregation).
Hash Code Contributors
Source MAC Address: Check the box to include the SMAC in the Hash Code. The Source MAC address can be
used to calculate the destination port for the frame. Check to enable the use of the Source MAC address or
uncheck to disable. By default, Source MAC Address is enabled.
Destination MAC Address: Check the box to include the DMAC in the Hash Code. The Destination MAC
Address can be used to calculate the destination port for the frame. Check to enable the use of the Destination
MAC Address or uncheck to disable. By default, Destination MAC Address is disabled.
IP Address: Check the box to include the IP Address in the Hash Code. The IP address can be used to calculate
the destination port for the frame. Check to enable the use of the IP Address, or uncheck to disable. By default, IP
Address is enabled.
TCP/UDP Port Number: Check the box to include the TCP/UDP port number in the Hash Code. The TCP/UDP
port number can be used to calculate the destination port for the frame. Check to enable the use of the TCP/UDP
Port Number or uncheck to disable. By default, TCP/UDP Port Number is enabled.
To Next Page
Loading...
Need help?
General
