Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 206
Security > Management > Access Method
Configure access management table on this page. The maximum number of entries is 16. If the application's type
matches any one of the access management entries, it will allow access to the switch.
Mode: Indicates the access management mode operation. Possible modes are:
on: Enable access management mode operation.
off: Disable access management mode operation.
Delete: Check to delete the entry. It will be deleted during the next save.
VLAN ID: Indicates the VLAN ID for the access management entry.
Start IP Address: Indicates the start IP unicast address for the access management entry.
End IP Address: Indicates the end IP unicast address for the access management entry.
HTTP/HTTPS: Indicates that the host can access the switch from HTTP/HTTPS interface if the host IP address
matches the IP address range provided in the entry.
SNMP: Indicates that the host can access the switch from SNMP interface if the host IP address matches the IP
address range provided in the entry.
TELNET/SSH: Indicates that the host can access the switch from TELNET/SSH interface if the host IP address
matches the IP address range provided in the entry.
Buttons
Add New Entry: Click to add a new access management entry.
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
To Next Page
Loading...
Need help?
General
