Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 295
CFM > MEP Status
View CFM MEP Status on this page.
Domain: Name of Domain under which this MEP resides.
Service: Name of Service under which this MEP resides.
MEPID: The identification of this MEP.
Port: Port on which this MEP resides.
State: The current state:
Active Operational state of the MEP:
• off : OFF. This indicates that the MEP Admin State is disabled.
• down : DOWN. The MEP Admin State is enabled, but an error state exists.
• up : UP. The MEP Admin State is enabled, and no errors and defects exist.
Fng : The current state of the Fault Notification Generator State Machine. Value will be one of these:
State Description
reset No defect has been present since reset timer expired or the State Machine was last
reset.
defect A defect is present, but not for a long enough time to be reported.
reportDefect A transient state during which the defect is reported.
defectReported A defect is present, and some defect has been reported.
defectClearing No defect is present, but the ResetTime timer has not yet expired.
SMAC: This MEP's MAC address.
Defects : A MEP can detect and report a number of defects, and multiple defects can be present at the same
time. This is indicated by one of the following letter codes.
RDI received from at least one remote MEP.
Received Port Status TLV != psUp or Interface Status TLV != isUp.
C someRMEPCCMdefect
Valid CCM is not received within 3.5 times CCM interval from at least one
remote MEP.
E errorCCMdefect
Received CCM from an unknown remote MEP-ID or CCM interval
mismatch.
X xconCCMdefect
Received CCM with an MD/MEG level smaller than configured or wrong
MAID/MEGID (cross-connect).
To Next Page
Loading...
Need help?
General
