Lantronix SISPM1040-xxxx-L3 Web User Guide
33856 Rev. A https://www.lantronix.com/ 45
System > UPnP
Configure UPnP on this page. The goal of UPnP (Universal Plug and Play) is to allow devices to connect
seamlessly and to simplify the implementation of networks in the home (data sharing, communications, and
entertainment) and in corporate environments for simplified installation of computer components.
Mode: Indicates the UPnP operation mode. Possible modes are:
Enabled: Enable UPnP mode operation.
Disabled: Disable UPnP mode operation.
When the mode is Enabled, two ACEs are added automatically to trap UPNP related packets to CPU. The ACEs
are automatically removed when the mode is Disabled.
TTL: The Time To Live value is used by UPnP to send SSDP advertisement messages. Read only now.
Advertising Duration: The duration, carried in SSDP packets, is used to inform a control point or control points
how often it or they should receive an SSDP advertisement message from this switch. If a control point does not
receive any message within the duration, it will think that the switch no longer exists. Due to the unreliable nature
of UDP, in the standard it is recommended that such refreshing of advertisements to be done at less than one-half
of the advertising duration. In the implementation, the switch sends SSDP messages periodically at the interval
one-half of the advertising duration minus 30 seconds. Valid values are 66 - 86400.
IP Addressing Mode: IP addressing mode provides two ways to determine IP address assignment:
Dynamic: Default selection for UPnP. UPnP module helps users choosing the IP address of the switch
device. It finds the first available system IP address.
Static: User specifies the IP interface VLAN for choosing the IP address of the switch device.
Static VLAN Interface ID: The index of the specific IP VLAN interface. It will only be applied when IP Addressing
Mode is static. Valid configurable values are 1 - 4095. The default value is 1.
Buttons
Apply: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
To Next Page
Loading...
Need help?
General
