Networking (AMIS)
UX Mail Manual Chapter 2: Features ◆ 243
2
Setting Up Networking Site Restriction
Step 1 In the sending system, enter the site’s number (using # delimiters).
1.1 CUSTOMIZE: TENANT OPTIONS: [GENERAL] SITE’S NETWORK TELEPHONE NUMBER (PAGE 477) FOR MORE.
- Enter the number exactly as it should be dialed to reach the sending system, excluding the
leading 1 (if required) and trunk access codes.
✔ By default, this entry is
N (None).
Step 2 In the receiving system, enter this same number in the Network Mailbox and turn on Selected
Incoming Network Call Mode in System Options.
2.1 ENTER THE NUMBER IN THE FOLLOWING CUSTOMIZE: MAILBOX OPTIONS EDIT: NETWORK FIELDS:
- [NETWORK] NETWORK PREFIX NUMBER (PAGE 415).
-
[NETWORK] NETWORK COUNTRY CODE (PAGE 415).
- [NETWORK] NETWORK AREA CODE (PAGE 415).
-
[NETWORK] NETWORK PHONE NUMBER (PAGE 416).
- The mailbox can be either a Network Remote Mailbox or a Network Alias Mailbox.
✔ By default, these entries are
N (None).
2.2
C
USTOMIZE
: S
YSTEM
O
PTIONS
:
[GENERAL 1]: INCOMING NETWORK CALL MODE (PAGE 459)
.
- Choose Selected.
- By default, this option is
N (None).
To Next Page
Loading...
