NEC UX5000 User Manual

Customize
System Options: [Dial Strings]
470 ◆ Chapter 3: Programming UX Mail Manual
● W (Wait for dial tone)
This command waits for CO dial tone, and then continues.
● $ - Not used.
Default
✔ W**
[Dial Strings] Ringdown
Use this option to set up the Ringdown string. When voice mail sets up Call Announcing or Call Waiting, it
dials this string to tell the UX5000
not to connect the outside call when the extension use lifts the handset.
Options
● Digits (20 maximum, using 0-9, # and *)
● N (None)
● A (Analyzed pause)
This command waits for 4 seconds, and then continues if busy tone or reorder tone are not detected.
● F (Flash)
This command hook flashes the voice mail port, which places it on Hold.
- To set the duration of the Flash, go to
[TIMERS] FLASH TIMER (PAGE 474).
● M (Monitored pause)
This command waits for 2 seconds, and then continues if busy tone or reorder tone are not detected.
● P (Pause)
This command waits for 2 seconds and then continues.
● S (Wait for sound)
This command waits 2 seconds for any constant sound (such as non-standard dial tone), and continues
if sound is detected.
● W (Wait for dial tone)
This command waits for CO dial tone, and then continues.
● $ - Not used.
Default
✔ 1
[Dial Strings] Off Hook Call Announce
Not used.
[Dial Strings] Conference
Use this option to set up the dial string voice mail uses to set up a Conference.
Options
● Digits (20 maximum, using 0-9, # and *)
● N (None)
● A (Analyzed pause)
This command waits for 4 seconds, and then continues if busy tone or reorder tone are not detected.
● F (Flash)
This command hook flashes the voice mail port, which places it on Hold.
- To set the duration of the Flash, go to
[TIMERS] FLASH TIMER (PAGE 474).
● G (Number of messages)
This command provides the number of new messages in the mailbox of extension receiving the lamp
update.
● M (Monitored pause)
This command waits for 2 seconds, and then continues if busy tone or reorder tone are not detected.
● P (Pause)
This command waits for 2 seconds and then continues. You can enter a pause command anywhere in
the dial string.
This dial string is automatically set during installation. You
should not change this entry from its default setting.

NEC UX5000 Specifications

General

Brand	NEC
Model	UX5000
Category	Telephone
Language	English