UX Mail Administrator Program
20 â—† Installation UX Mail Manual
Resetting the UX Mail Blade
You should reset the UX Mail blade after changing the TCP/IP address, gateway address, or DNS address.
You may also need to reset the blade for maintenance purposes. Resetting the blade will also restart the asso-
ciated voice mail application program.
To reset the UX Mail blade:
1. Press the LOAD button on the UX Mail front panel for about 3 seconds until the four front panel LEDS
are on (solid).
2. Release the LOAD button.
3. The UX Mail blade and voice mail application program will restart in about 3 minutes.
UX Mail Reset LED Patterns
LED After pressing LOAD for 3 seconds
CompactFlash Activity On red
Voice Mail Application On yellow
Voice Mail Port Status On
Run Status On green
To Next Page
Loading...
Need help?
General