EasyManua.ls Logo

NEC UX5000 - Before Fax Local Callout; Before Fax Long Distance Callout; [Access Digits] before Network Long Distance Callout

NEC UX5000
588 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Customize
Tenant Options: [Access Digits]
482 Chapter 3: Programming UX Mail Manual
F (Flash)
This command hook flashes the voice mail port, which places it on Hold.
- To set the duration of the Flash, go to
[TIMERS] FLASH TIMER (PAGE 474).
M (Monitored pause)
This command waits for 2 seconds, and then continues if busy tone or reorder tone are not detected.
P (Pause)
This command waits for 2 seconds and then continues. You can enter a pause command anywhere in
the dial string.
S (Wait for sound)
This command waits 2 seconds for any constant sound (such as non-standard dial tone), and continues
if sound is detected.
W (Wait for dial tone)
This command waits for CO dial tone, and then continues.
$ - Not used.
Default
N (None)
[Access Digits] Before Network Long Distance Callout
This option is the dialing prefix that enables voice mail to seize an outside line to deliver a network message
to a remote system over a long distance number. Voice mail defines long distance numbers as more than 8
digits long.
A typical entry is 9P, where:
-
9 is the trunk access code.
-
P is a pause.
Options
Digits (30 maximum, using 0-9, # and *)
N (None)
A (Analyzed pause)
This command waits for 4 seconds, and then continues if busy tone or reorder tone are not detected.
F (Flash)
This command hook flashes the voice mail port, which places it on Hold.
- To set the duration of the Flash, go to
[TIMERS] FLASH TIMER (PAGE 474).
M (Monitored pause)
This command waits for 2 seconds, and then continues if busy tone or reorder tone are not detected.
P (Pause)
This command waits for 2 seconds and then continues. You can enter a pause command anywhere in
the dial string.)
S (Wait for sound)
This command waits 2 seconds for any constant sound (such as non-standard dial tone), and continues
if sound is detected.
W (Wait for dial tone)
This command waits for CO dial tone, and then continues.
$ - Not used.
Default
N (None)
Before Fax Local Callout
Not used.
Before Fax Long Distance Callout
Not used.

Table of Contents

Other manuals for NEC UX5000

Related product manuals