EasyManuals Logo

NEC UX5000 User Manual

NEC UX5000
588 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
Programming
UX Mail Manual Installation â—† 9
1
Having UX Mail Answer Trunk Calls
1. 22-02-01: INCOMING CALL TRUNK SETUP
Assign Service Type 4 to each trunk you want to be a DIL.
- Make a separate entry for each Night Service mode.
✔ By default, trunks are Service Type 0 (Normal).
2. 22-07-01: DIL ASSIGNMENT
For each trunk you designated as type 4 above, enter the first (lowest) voice mail extension number
as the DIL destination.
- These are the extensions you assigned to the UX Mail Department Group in step 2 on the
previous page.
- Make a separate entry for each Night Service mode.
✔ By default, there are no DIL destinations programmed.
Other UX Mail Programming You Should Check
1. 15-03-05: SINGLE LINE TELEPHONE BASIC DATA SETUP, EXTERNAL REVERSE
Disable (0) External Reverse for each voice mail port.
✔ By default, this option is disabled (0).
2. 15-03-06: SINGLE LINE TELEPHONE BASIC DATA SETUP, EXTENSION REVERSE
Disable (0) Extension Reverse for each voice mail port.
✔ By default, this option is disabled (0).
3. 15-03-09: SINGLE LINE TELEPHONE BASIC DATA SETUP, CALLER ID FUNCTION FOR EXTERNAL MODULE
3. Disable (
0) External Module Caller ID for each voice mail port.
✔ By default, this option is disabled (0).
4. 16-01-08: DEPARTMENT GROUP BASIC DATA SETUP, MINIMUM QUEUING NUMBER OF EXTENSION GROUP CALL
Optionally enable queuing (1) when all voice mail ports are busy.
✔ By default, this option is 0 (no queuing).
5. 45-02-01: NSL OPTION SETUP - SEND DTMF TONES OR 6KD MESSAGES
Enable (1) the 6KD Message.
- This enables the NSL messages between the system and UX Mail.
✔ By default, this option is 0 (DTMF).
6. 45-02-03: NSL OPTION SETUP - SEND 51A MESSAGES
Enable (1) the 51A Message.
- This enables the NSL call status messages that are required for Make Call and Message Noti-
fication callouts.
✔ By default, this option is
0 (disabled).
See the UX5000 Software Manual for additional voice mail programming.
1. To have the UX Mail Automated Attendant answer outside calls, set up DILs to voice mail.
1. Be sure to check the following additional UX Mail programming.

Table of Contents

Other manuals for NEC UX5000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC UX5000 and is the answer not in the manual?

NEC UX5000 Specifications

General IconGeneral
BrandNEC
ModelUX5000
CategoryTelephone
LanguageEnglish

Related product manuals