Customize
Mailbox Options: Subscriber: [Email]
442 ◆ Chapter 3: Programming UX Mail Manual
[Email] Smtp Server
Use this option to specify the name of the SMTP (Simple Mail Transfer Protocol) server that handles outgo-
ing messages for the subscriber’s email account. The SMTP server name is typically similar to
smtp.emailserver.com. If you don’t make an entry in the Domain Name option below, this entry must be the
IP address of your email server.
Options
● Up to 80 alphanumeric characters.
Default
✔ No entry.
[Email] Domain Name
Use this option to enter the name of the site’s Domain Name Server (DNS). The Domain Name Server (DNS
or name server) is the computer connected to the internet that converts a domain name (such as necunified-
solutions.com) to a specific IP address for routing on the internet.
● To specify the IP address of the Name Server, go to SETTING THE DOMAIN NAME SERVER (PAGE 12).
● If you entered your entire email address in [Email] EMAIL NAME, you don’t have to make an entry in this
option.
Options
● Up to 80 alphanumeric characters.
Default
✔ No entry.
[Email] Smtp Port
Use this option to specify the port (logical connection) in the email server uses for SMTP. Normally, this is
port 25 (which is preassigned by the IANA as the “Well-Konwn TCP Port Number” for SMTP).
Options
● Digits (6 digits max, using 0-9).
Default
✔ No entry.
[Email] Smtp SSL
Use this option to enable or disable SSL (Secure Sockets Layer) encryption for the subscriber’s outgoing
mail. Only enable this option if the email provider’s SMTP server supports SSL encryption (i.e., has a valid
SSL Certificate).
Options
● Yes (SSL encryption enabled).
● No (SSL encryption disabled).
Default
✔ No (SSL encryption disabled).
[Email] Smtp Authentication
Use this option to specify the method of SMTP Authentication required by the SMTP server. The authenti-
cation methods supported are Login, DRAM MD5, or None.
Options
● None.
● Login.
● DRAM MD5.
Default
✔ None.