Customize
Mailbox Options: Subscriber: [Subscriber]
UX Mail Manual Chapter 3: Programming ◆ 437
3
Mailbox Options: Subscriber: [Subscriber]
Subscriber Tab
[Subscriber] Park/Paging String
Use this option to set up the Park and Page string. voice mail uses this string to make a Personal Park at the
subscriber’s extension and then Page the subscriber with the prerecorded Paging Message.
● To use Park and Page, the Subscriber Mailbox must have the Paging Message Recorded. From the
subscriber’s mailbox, use
PG + R + Record message + # to record the Paging Message.
● Park and Page interacts with Personal Greeting.
● See PARK AND PAGE (PAGE 251) for more.
Options
● Digits (20 maximum, using 0-9, # and *)
● N (None)
● A (Analyzed pause)
This command waits for 4 seconds, and then continues if busy tone or reorder tone are not detected.
● F (Flash)
This command hook flashes the voice mail port, which places it on Hold.
- To set the duration of the Flash, go to
[TIMERS] FLASH TIMER (PAGE 474).
● H (Hang up)
This command tells voice mail to hang up. To set the duration of the Hang Up Timer, see Customize:
System Options:
[TIMERS] HANG UP TIMER (PAGE 475).
● M (Monitored pause)
This command waits for 2 seconds, and then continues if busy tone or reorder tone are not detected.
Compatibility Guidelines:
■ When using the UX Mail Administrator to enter dial strings, take care not to enter illegal characters
(such as dashes). Enter only those characters allowed by the option you are programming.
The Park/Paging string is automatically set up during voice mail installation.
Normally, you should not change this option from its default value.
To Next Page
Loading...
Need help?
General