Customize
Tenant Options: [General]
UX Mail Manual Chapter 3: Programming ◆ 479
3
[General] Digital Pager Callback Number
Use this option to set the Digital Pager Callback Number portion of the Message Notification callout num-
ber for a digital pager. This is the portion of the callout number that is appended to the pager service number.
Normally, this option should be X*M#, where:
- X the number of the extension that generated the notification.
- * is a visual delimiter (to make the pager display easier to read).
- M is the number of new messages in the extension’s mailbox.
- # is the digit normally used by the pager service for positive disconnect.
● See MESSAGE NOTIFICATION (PAGE 199) for more.
Options
● Digits (12 maximum, using 0-9, # and *)
● M (Number of messages)
Note that the M command for this option has a unique definition.
● N (None)
● X (Extension number)
Voice mail automatically replaces the X command with the number of the extension that initially
received the message.
Default
✔ X*M# (None)
[General] Delay in Dialing Pager Callback Number
Use this option to set the delay that occurs just before voice mail dials the Digital Pager Callback Number
portion of the Message Notification callout number for a digital pager. Set this delay so the pager service has
enough time to connect to the digital pager before sending the callback number. Your pager service may be
able to help you determine the best value for this option (0-99 seconds).
● See MESSAGE NOTIFICATION (PAGE 199) for more.
Options
● 0-99 seconds
Default
✔ 13 seconds
[General] Delay Before Pager Announcement
Use this option to set the delay that occurs after voice mail dials a radio pager notification number but before
it broadcasts the radio pager voice announcement.
● See MESSAGE NOTIFICATION (PAGE 199) for more.
Options
● 0-99 seconds
Default
✔ 18 seconds
[General] Remote Tenant Enabled
This option is not used.
[General] Access Digits for Remote Tenant
This option is not used.