Customize
Mailbox Options: Subscriber: [Messaging]
432 ◆ Chapter 3: Programming UX Mail Manual
[Messaging] Urgent Message Return Time
Use this option to enable or disable the ability of voice mail to provide the Subscriber Mailbox user with the
status of Urgent Messages they have sent. When the Subscriber Mailbox user sends an urgent message,
voice mail waits this interval to determine if the recipient has listened to the message. If not, when the sub-
scriber dials
L to listen to their messages, voice mail plays a voice prompt indicating that the urgent message
has not been heard. It then plays a copy of the urgent message.
● See URGENT MESSAGE (PAGE 302) for more.
Options
● 1-999 Minutes
● N (None)
Default
✔ N (None)
[Messaging] Recording Conversation Beep
Use this option to enable or disable the Conversation Record beep. If enabled, all parties on a call will hear
the voice prompt Recording followed by a beep when the extension user initiates Conversation Record. If
disabled, the voice prompt and beep will not occur.
● See CONVERSATION RECORD (PAGE 108) for more.
Options
● Yes or No.
Default
✔ Yes
[Messaging] Ask Caller’s Number
Use this option to enable the Make Call feature for the Subscriber Mailbox. Once enabled, voice mail asks
the caller leaving a message to enter their number prior to leaving the message. This allows the subscriber to
listen to the message and then dial
MC to call the person back – without knowing the caller’s number. Nor-
mally, this feature is used when Caller ID is not available or installed.
● This option is not required for Make Call to work to UX5000 extensions. It is only required to enable
Make Call for outside (Automated Attendant) callers.
● Make Call follows the same programming and restrictions as Message Notification.
● See MAKE CALL (PAGE 186) for more.
Options
● Yes or No.
Default
✔ No
To Next Page
Loading...
